Speki+ is the upgrade DSM2/DSMX/SRXL protocol compatible Micro 2.4Ghz receiver, it comes with PA module, longer range and stable signal transmission, with RSSI telemetry. You can get the RSSI from Betaflight OSD Specifications : Brand: Happymodel Model Name: Speki+ Weight: 1.2g Dimension: 20mm*12.4mm*5mm Support protocol: DSM2/DSMX Output Signal configuration: SRXL(Set Spektrum2048/SRXL for the serial receiver provider) Antenna connector: I-PEX MHF3 Antenna length: 70mm Input voltage:…

ELRS Fyujon is a very simple and easy-to-use 2-in-1 module that integrates 5.8GHz video transmission and 2.4GHz ELRS receiver. They can be integrated into a board for use, or they can be split into independent VTX modules and receiver modules to be used separately. They are all open source solutions that are currently very popular with FPV pilots. Compatible with 20mmx20mm, 30mmx30mm stack mounted way and 25.5mmx25.5mm whoop mounted way. Due to the ultra light weight (only2.1gram), it would be a…

This is a micro flysky compatible receiver that is estimated to give you at around 500m range making it one of the best flysky compatible receivers to use on your FPV quadcopter. This receiver uses the AFHDS-2A and is fully compatible with betaflight/iNav. The diversity antennas give you great range and this receiver also outputs RSSI on channel 14, allowing you to keep an eye on your signal to avoid a out of range failsafe. Key Features – Customized for Betaflight – RSSI Display Via O…

The Happymodel ExpressLRS PWM Kit incudes a 6CH EPW6 900MHz Receiver with two antennas and three 6-pin adapters. Perfect for your Fixed Wing airplane! Features Fixeded Wing Receiver Kit EPW6 900MHz PWM RX 915MHz Antenna 868MHz Antenna BINDING PROCEDURE Supply power to the EPW6 RX, wait until the Green LED on the RX is off, immediately turn off the power, and then repeat again the above steps. When the RX is powered on for the third time, the Green LED light will start…

The Happymodel ExpressLRS PWM Kit incudes a 5CH EPW5 2.4GHz Receiver with two antennas and three 6-pin adapters. Perfect for your Fixed Wing airplane! Features Fixeded Wing Receiver Kit EPW5 2.4GHz PWM RX 2.4GHz Antennas BINDING PROCEDURE Supply power to the EPW5 RX, wait until the Green LED on the RX is off, immediately turn off the power, and then repeat again the above steps. When the RX is powered on for the third time, the Green LED light will start to double-f…

The Happymodel 2.4GHz ELRS nano series receiver has an open-source program based on ExpressLRS. There are three in this series. The PP RX is designed by @Jye Smith from the ExpressLRS development team. Its main hardware architecture is STM32L432KBU6 MCU and SX1280 RF chip. It has a built-in ceramic antenna, which is super light and small in size. On the basis of PP RX, Happymodel has have developed the Nano 2.4GHz RX of ESP8285 version named EP1 and EP2. The RF module of EP1/EP2 is the same …

The Happymodel 2.4GHz ELRS nano series receiver has an open-source program based on ExpressLRS. Due to the low-latency and high-refresh-rate RF module, they are very comfortable for FPV Racing and Long Range FPV. These are very suitable for Tiny whoops because of the ultra-light and Nano size! The Series There are three in this series. The PP RX is designed by @Jye Smith from the ExpressLRS development team. Its main hardware architecture is STM32L432KBU6 MCU and SX1280 RF chip. It has a bui…

The ES900TX and ES900RX modules sets are long-distance 915mhz wireless transmission equipment developed and designed based on the open-source ExpressLRS software. This set of modules is characterized by ultra-long-range, stable operation, and low latency. They are compatible with most Opentx remote controllers, especially suitable for Radiomaster TX16S and Jumper T12, T16, and T18 series remote controllers, and are basically plug and play. The heat sink has been specially customized for the tr…

The ES900RX module is a long-distance 915mhz wireless receiver developed and designed based on the open-source ExpressLRS software. This module is characterized by ultra-long-range, stable operation, and low latency. It is compatible with most Opentx remote controllers, especially suitable for Radiomaster TX16S and Jumper T12, T16, and T18 series remote controllers, and are basically plug and play. Note: Radio and TX Not Included VIDEO: Happymodel ExpressLRS 900mhz TX & RX System …

Happymodel ExpressLRS ELRS Fyujon 2IN1 AIO Module Built-in ELRS 2.4GHz EP Receiver OpenVTX 5.8G 48CH 300mW for FPV Toothpick Cinewhoop Drone OVERVIEW: ELRS Fyujon is a very simple and easy-to-use 2-in-1 module that integrates 5.8GHz video transmission and 2.4GHz ELRS receiver. They can be integrated into a board for use, or they can be split into independent VTX modules and receiver modules to be used separately. They are all open source solutionss that are currently very popular with FPV p…

Introduce the World first true diversity 2.4 GHz ExpressLRS Rx with RF amps Item: Happymodel EP1 Dual receiver true diversity 2.4Ghz ExpressLRS RX ESP32 PICO D4, dual SX1280(SX1281) Antenna connector: IPEX MHF 1/U.FL RF Frequency: 2.4GHz (2400~2480MHz) Telemetry power: >19dbm Receiver protocol: CRSF Input voltage: 3.5v~8.4v Recommend +5V DC @ “+” pad PCB size: 19mm x 14mm Weight: 1gram exclude antenna Firmware: ExpressLRS v3.0.0 rc1 or latest version Target: Unified_ESP32_2400_RX, …

EP2 TCXO Receiver Type: ISM2.4GHz ESP8285 MCU SX1280(SX1281)IMLTRT RF Module SMD Ceramic antenna Frequency Range: 2400 MHz to 2500 MHz Receive refresh rate: 25HZ~500Hz Working voltage: 5v Weight: 0.44 gram Dimension: 10mm*10mm*6mm Peak gain: 3.7dB Default Firmware out of factory: HappyModel_EP_2400_RX V3.0.1 version Built-in a TCXO (temperature compensated crystal oscillator)

EP1 TCXO Receiver Type: ISM2.4GHz ESP8285 MCU SX1280(SX1281)IMLTRT RF Module Omni directional antenna Frequency Range: 2400 MHz to 2500 MHz Receive refresh rate: 25HZ~500Hz Working voltage: 5v Weight: 0.41 gram(without antenna) Dimension: 10mm*10mm*6mm Peak gain: 2.23dB Default Firmware out of factory: HappyModel_EP_2400_RX V3.0.1 version Built-in a TCXO (temperature compensated crystal oscillator)

Summary GEPRC ELRS NanoSE receiver is a new generation remote control system developed based on the ExpressLRS open source project. ExpressLRS sets new standartds for long-range connection, low latency and Maximum refresh rate of 500Hz. GEPRC ELRS NanoSE receiver operates at a frequency of 2.4 GHz. Compared with Nano receiver, NanoSE receiver uses an Integrated SMD ceramic antenna, which further reduces its size while ensuring signal reception, making it more suitable for use on drones w…

Summary GEPRC ELRS Nano 915M V2 Receiver is a new generation receiver system based on ExpressLRS open source project.ExpressLRS features long range operation, low latency, and low price. The ELRS Nano 915M V2 Receiver uses a TCXO temperature compensated crystal oscillator to avoid frequency shifts caused by temperature changes;the telemetry power is up to 50mW; Built-in WIFI antenna, firmware upgrade operation through WIFI. Feature 17x11mm Small size 0.7g weight WIFI Upgrade firm…

Summary The GEPRC ELRS Nano 915M PA500 receiver is an advanced reception system based on the ExpressLRS open-source project. ExpressLRS offers long-range operation, low latency, high refresh rates, and affordability. The ELRS Nano 915M PA500 receiver features a TCXO (temperature-compensated crystal oscillator) to prevent frequency shifts caused by temperature changes. It adopts an integrated high-power PA chip, boasting a telemetry power of up to 500mW. It features a built-in WIFI antenna, f…

Summary The GEPRC ELRS Nano 915M/2.4G Dual-Band Receiver is a new Dual-Band system developed from the ExpressLRS open-source project. It is designed based on Semtech’s third-generation LR1121 RF chip, supporting 150 – 960MHz (sub-GHz) and 2.4GHz bands for Dual-Band transmission. The ELRS Nano 915M/2.4G Dual-Band Receiver features dual LR1121 chips, allowing easy switching between 915M , 2.4G when paired with 915M/2.4G antennas. It is fully compatible with existing 915M and 2.4G ELRS TX modul…

Summary GEPRC ELRS Nano 2.4G PA100 Receiver is a new generation of 2.4G receiver system based on ExpressLRS open source project.ExpressLRS features long range operation, low latency, maximum 1000Hz refresh rate, and low price. The ELRS Nano 2.4G PA100 Receiver uses a TCXO temperature compensated crystal oscillator to avoid frequency shifts caused by temperature changes;Integrated PA+LNA,the telemetry power is up to 100mW; Built-in WIFI antenna, firmware upgrade operation through WIFI. Feat…

About this item ELRS Dual 915M PA500 Diversity Receiver High-Power 500mW WIFI TCXO for RC FPV Quadcopter Longrange Freestyle Drone Parts ELRS 915M PA500 Diversity Receiver for RC FPV Quadcopter Drone Parts Optimized performance: Equipped with a high-power PA chip, it ensures strong signal strength and reliability for your FPV quadcopter project. Enhanced power output: With 500mW power output, this receiver improves the range and responsiveness of your drone, making it ideal for long-ra…

Summary The GEPRC ELRS 915M/2.4G Gemini Xrossband Receiver is a new dual-band system developed from the ExpressLRS open-source project. It is designed based on Semtech’s third-generation LR1121 RF chip, supporting 150 – 960MHz (sub-GHz) and 2.4GHz bands for simultaneous dual-band transmission. The ELRS 915M/2.4G Gemini Xrossband Receiver features dual LR1121 chips, allowing easy switching between 915M Gemini, 2.4G Gemini, and dual-band 915M+2.4G modes (requires dual-band TX module support) w…

rSky XM+ Receivers are now coming installed with ACCST 2.0 firmware. This is not compatible with ACCST 1.0 controllers and firmware updates will be required if there is a firmware mismatch. Firmware can be found here: https://www.frsky-rc.com/xm-plus-mini-sbus-non-telemetry-full-range/ (Select history firmware download for ACCST 1.0 firmware) FrSky XM+ Ultra Mini SBUS Receiver , ONLY 1.6g Specification Dimension : 21.5x12x3.5mm(LxWxH) Weight : 1.6g Number of Channels : Up to 16CH f…

The X8R is in a smaller package than the previous 8 channel receivers but has so much more capability. The new Smart Port supports the new hub-less sensors as well as the older hub analog sensors. The X8R supports 8 standard servo outputs, and you can access all 16 channels by using the Sbus line with Sbus supported servos or use a FrSky S.BUS Decoder for the full 16 channels. Or you can use 2 X8R receivers in combination and the channels will sync 1-8 on the first and 9-16 on the second. Th…

Frsky R-XSR receivers are now coming installed with ACCESS firmware. To bind with ACCST only radios, a firmware update is required. Firmware can be found here: https://www.frsky-rc.com/r-xsr/ (Select history firmware download for ACCST 1.0 firmware) The FrSky ultra mini receiver R-XSR is the evolution of the popular full range XSR receiver. The R-XSR is a standalone receiver with all the functionality of the full size XSR (including telemetry), but at 1/3 size and weight of XSR receiver.…

Flysky X8B 2.4G 8CH PPM i-BUS Mini Receiver for AFHDS 2A FS-NV14 RC Drone Radio Specification: Brand name: Flysky Item name: X8B Receiver Channels: 8 Model Type: Multi Rotor Data Output: PPM/i-Bus Frequency Range: 2.408-2.475GHz Brandwidth: 500KHz Number of Bands: 135 Transmission Power: <20dBm Receiver Sensitivity: -92dBm 2.4GHz Protocol: AFHDS 2A Modulation: GFSK Low voltge alarm: None Chargeable: None Antenna length: 93mm Input Power: 4.0-8.4V Online Update: None No ground…